We are also proud to launch our AS4687/2007 certified panels:2100mm (H) x 2400mm (L) and primer comply with AS/NZS3750.15 ,the wire of temporary fencing panels are consist of 2.5mm to 4.00mm among all diameter 3.80mm ,4.00mm as well 3.00mm was most common in temporary fence you saw Our top of the range panel is manufactured for its robustness in remote and extreme climates. These products withstand these environments and are best suited for the Resource and Hire industries . Our flagship panel specification:

• Anti -climb mesh infill

• 360° weld between the vertical & horizontal pipe

• Horizontal pipe ends crimped for increased strength.

• Above Industry Benchmark in thickness of galvanising

• 1.94 Metre Top Horizontal Pipe for extra security

The manufacturing process uses hand welding for optimum strength with an average of over 70 micron hot dipped galvanised finish. We use the highest quality material specification, incorporating:

• Frame – 32mm diameter horizontal and vertical pipes with a min 2mm wall thickness

• Mesh - 4mm horizontal and vertical wire with 150mm x 60mm spacing's

All Temporary Fencing plastic bases (feet) are a high quality, heavy duty, long life product,

which are much smarter in appearance than the original concrete or steel feet. Your temporary

fence will look great and be safer with these highly visible orange coloured feet. Our feet are

more durable, will last longer, are easier to handle, and are not prone to falling apart or chipping.

We stock a range of feet as listed below:

1. Blow moulded concrete filled plastic feet

The plastic bases stack conveniently by interlocking into the foot below them for easy and safe

transport. The blow moulded plastic feet are filled with concrete which make them extremely

durable as the entire concrete base is encased in plastic. This will prolong the life of the foot

which will save you money in the long run.

2. Injection Moulded concrete filled plastic feet

These are the basic feet used by many of the temporary fencing companies in Australia. The concrete is poured in from the underside and the feet have two steel reinforcing rods.

Stays

Temporary fence stays are used to support the temporary fence in high wind situations or on long runs to ensure the fence once erected remains secure.Our specialist installation guys will access the site and install stays if required.

Fence stays are hot dipped galvanised to Australian Standard - 42 Microns and are attached to the mesh panels by 2 clamps and weighted down by concrete filled plastic feet.